ZyXEL Communications ZyWALL 310 - 25.2 ALG Commands

Chapter 25 ALG
ZyWALL Series CLI Reference Guide
212
25.2 ALG Commands
The following table lists the alg commands. You must use the configure terminal command to
enter the configuration mode before you can use these commands.
Table 107 alg Commands
COMMAND DESCRIPTION
[no] alg sip [direct-media |
direct-signalling |
inactivity-timeout | |
media-timeout <1..86400> |
signal-timeout <1..86400> |
transformation]
Turns on or configures the ALG.
Use direct-media to to set the Zyxel Device to allow SIP audio session.
Use direct-signalling to set the Zyxel Device to allow SIP signaling
sessions.
Use inactivity-timeout to have the Zyxel Device apply SIP media and
signaling inactivity time out limits.
Use media-timeout and a number of seconds (1~86400) for how long to
allow a voice session to remain idle (without voice traffic) before dropping it.
Use signal-timeout and a number of seconds (1~86400) for how long to
allow a SIP signaling session to remain idle (without SIP packets) before
dropping it.
Use transformation to have the Zyxel Device modify IP addresses and port
numbers embedded in the SIP data payload. You do not need to use this if
you have a SIP device or server that will modify IP addresses and port
numbers embedded in the SIP data payload.
The no command turns off the SIP ALG or removes the settings that you
specify.
alg sip defaultport Enters ALG SIP default port sub-command
Router(SIP Signaling
Port)# [no] port
<1025..65535>
Enter the custom UDP port number for SIP traffic. The no command removes
the custom UDP port number for SIP traffic.
[no] alg <h323 | ftp>
[signal-port <1025..65535> |
signal-extra-port
<1025..65535> |
transformation]
Turns on or configures the H.323 or FTP ALG.
Use signal-port with a listening port number (1025 to 65535) if you are using
H.323 on a TCP port other than 1720 or FTP on a TCP port other than 21.
Use signal-extra-port with a listening port number (1025 to 65535) if you
are also using H.323 or FTP on an additional TCP port number, enter it here.
Use transformation to have the Zyxel Device modify IP addresses and port
numbers embedded in the H.323 or FTP data payload. You do not need to
use this if you have an H.323 or FTP device or server that will modify IP
addresses and port numbers embedded in the H.323 or FTP data payload.
The no command turns off the H.323 or FTP ALG or removes the settings that
you specify.
show alg <sip | h323 | ftp> Displays the specified ALG’s configuration.