ZyXEL Communications ZyWALL 310 - Application Object; 51.1 Application Object Commands Summary; 51.1.1 Application Object Commands

Chapter 51 Application Object
ZyWALL Series CLI Reference Guide
457
CHAPTER 51
Application Object
Check that you have the latest IDP and App Patrol signatures.
51.1 Application Object Commands Summary
The following table describes the values required for many application object commands. Other values
are discussed with the corresponding commands.
51.1.1 Application Object Commands
This table lists the application object commands.
Table 256 Input Values for Application Object Commands
LABEL DESCRIPTION
<object>
Type the name of the object.
<description
>
This is a description of the object
<sid>
This is the associated IDP and App Patrol signature ID number.
Table 257 application-object Commands
COMMAND DESCRIPTION
show application-object <object>
Displays information on the named application object.
application-object <object>
Creates an object with the specified name. You may use
1-31 alphanumeric characters, underscores(
_), or dashes
(-), but the first character cannot be a number. This value
is case-sensitive. The no command disables it.
[no] description <description>
Write a description of the object.
[no] application <sid>
Write a valid signature ID for the object. The no command
disables it.
no application-object <object>
Deletes the object with the specified name.
application-object rename <object>
<object>
Renames the specified object with a new name.