Chapter 16 Interfaces
ZyWALL Series CLI Reference Guide
152
16.7.1 Tunnel Interface Command Examples
This example creates a tunnel interface called tunnel0 that uses wan1 as the source, 168.168.168.168 as
the destination, and 10.0.0.100 and 255.255.0.0 as the inner source IP.
16.8 USB Storage Specific Commands
The Zyxel Device can use a connected USB device to store system logs, diagnostic information and
firmware.
Note: The USB device must allow writing (it cannot be read-only) and use the FAT16, FAT32,
EXT2, or EXT3 file system.
For Zyxel Devices that have more than one USB port, these commands only apply to the
first USB storage device that is attached to the Zyxel Device.
Use these commands to configure settings that apply to the USB storage device connected to the Zyxel
Device.
You must be in configuration mode (configure terminal) to use the indented commands shown
below.
Router> configure terminal
Router(config)# interface tunnel0
Router(config-if-tunnel)# tunnel source wan1
Router(config-if-tunnel)# tunnel destination 168.168.168.168
Router(config-if-tunnel)# ip address 10.0.0.100 255.255.0.0
Router(config-if-tunnel)# exit
Router(config)# show interface tunnel
tunnel interface: 1
interface name: tunnel0
local address: ge2
local address type: bind
remote address: 168.168.168.168
mode: gre
IP address: 10.0.0.100
netmask: 255.255.0.0
status: Inactive
active: no
Table 69 USB Storage General Commands
COMMAND DESCRIPTION
show usb-storage
Displays the status of the connected USB storage device.
[no] usb-storage
activate
Enables or disables the connected USB storage service.
usb-storage warn number
<percentage|megabyte>
Sets a number and the unit (percentage or megabyte) to have the Zyxel
Device send a warning message when the remaining USB storage space
is less than the set value.
usb-storage mount
Mounts the connected USB storage device.
usb-storage umount
Unmounts the connected USB storage device.
To Next Page
Loading...
