ZyXEL Communications ZyWALL 310 - Object Reference; 3.1 Object Reference Commands

ZyWALL Series CLI Reference Guide
45
CHAPTER 3
Object Reference
This chapter describes how to use object reference commands.
3.1 Object Reference Commands
The object reference commands are used to see which configuration settings reference a specific
object. You can use this table when you want to delete an object because you have to remove
references to the object first.
Table 6 show reference Commands
COMMAND DESCRIPTION
show reference object username
[username]
Displays which configuration settings reference the specified user object.
show reference object address
[object_name]
Displays which configuration settings reference the specified address object.
show reference object address6
[object_name]
Displays which configuration settings reference the specified IPv6 address
object.
show reference object service
[object_name]
Displays which configuration settings reference the specified service object.
show reference object schedule
[object_name]
Displays which configuration settings reference the specified schedule
object.
show reference object interface
[interface_name |
virtual_interface_name]
Displays which configuration settings reference the specified interface or
virtual interface object.
show reference object aaa
authentication [default |
auth_method]
Displays which configuration settings reference the specified AAA
authentication object.
show reference object ca category
{local|remote} [cert_name]
Displays which configuration settings reference the specified authentication
method object.
show reference object account pppoe
[object_name]
Displays which configuration settings reference the specified PPPoE account
object.
show reference object account pptp
[object_name]
Displays which configuration settings reference the specified PPTP account
object.
show reference object app-patrol
[profile-name]
Displays which configuration settings reference the specified application
patrol profile.
show reference object sslvpn
application [object_name]
Displays which configuration settings reference the specified SSL VPN
application object.
show reference object crypto map
[crypto_name]
Displays which configuration settings reference the specified VPN
connection object.