Chapter 72 Miscellaneous
ZyWALL Series CLI Reference Guide
602
72.4 GUI Visibility
The GUI visibility commands show or hide advanced features in the Web Configurator.
Table 347 gui-visibility Commands
COMMAND DESCRIPTION
[no] gui-visibility gui-
visibility policy-route-
fromlocal-snat
Allows you to configure Source Network Address Translation (SNAT) when
Incoming interface is set to “ZyWALL” in the Web Configurator at Configuration
> Network > Routing > Policy Route > Add/Edit Policy Route.
The no command prevents this setting from being configured.
Note: This command is available in ZLD firmware 5.0 and later.
[no] gui-visibility
show-advanced
show gui-visability
status
Displays the current GUI visibility settings.
To Next Page
Loading...
