Chapter 64 System Remote Management
ZyWALL Series CLI Reference Guide
528
CHAPTER 64
System Remote
Management
This chapter shows you how to determine which services/protocols can access which Zyxel Device
zones (if any) from which computers.
Note: To access the Zyxel Device from a specified computer using a service, make sure no
service control rules or to-Zyxel Device firewall rules block that traffic.
64.1 Remote Management Overview
You may manage your Zyxel Device from a remote location via:
To disable remote management of a service, deselect Enable in the corresponding service screen.
64.1.1 Remote Management Limitations
Remote management will not work when:
1 You have disabled that service in the corresponding screen.
2 The accepted IP address in the Service Control table does not match the client IP address. If it does not
match, the Zyxel Device will disconnect the session immediately.
3 There is a firewall rule that blocks it.
64.1.2 System Timeout
There is a lease timeout for administrators. The Zyxel Device automatically logs you out if the
management session remains idle for longer than this timeout period. The management session does
not time out when a statistics screen is polling.
Each user is also forced to log in the Zyxel Device for authentication again when the reauthentication
time expires.
• Internet (WAN only) • ALL (LAN&WAN&DMZ)
• LAN only •DMZ only
To Next Page
Loading...
