Chapter 11 Wireless Health
ZyWALL Series CLI Reference Guide
106
11.2.1 Wireless Health Radio and Station Settings
The following table describes the configuration commands available for the wireless health radio and
station. You must be in the configuration mode to configure a specified radio profile before you can use
the commands. Commands that do not have IPv6 specified in the description are for IPv4.
Table 37 Command Summary: Wireless Health
COMMAND DESCRIPTION
wireless-health radio {action |
act-lock-time <1...1440> |
recovery-threshold <10...1000>|
act-threshold <10...1000>| data-
collect-interval <0...120>}
action: Configure the actions taken to improve the AP wireless
network performance. See Section 11.2.2 on page 107 for more
information on radio actions commands.
act-lock-time: Configure the length of time in seconds the
Zyxel Device cannot implement the action you set to the APs in a
poor state of wireless health. For example, if you set the time to 30,
the Zyxel Device can only have the AP choose a channel that has
the least interference (DCS) or change the AP channel bandwidth
from 80MHz to 20MHz (adaptive channel width) once even if the
Zyxel Device detects that the AP is in a poor state of wireless health
more than once within 30 seconds.
recovery-threshold: Configure the length of time in
seconds the AP changes the channel bandwidth from 20 MHz to
80 MHz. Use this command if you set the action to
downgrade_cw, which will change the AP channel bandwidth
from 80MHz to 20 MHz. See Section 11.2.2 on page 107 for more
information.
act-threshold: Configure how many times the AP has to
resend the packets will trigger the action you set. For example, if
you set the threshold to 10, the Zyxel Device will have the AP
choose a channel that has the least interference (DCS) or change
the AP channel bandwidth from 80MHz to 20MHz (adaptive
channel width) if the AP has to try 10 times before it can send out
packets successfully.
data-collect-interval: Configure the time period over
which the AP wireless health state is recorded.
wireless-health sta {action |
act-lock-time <1...1440>| act-
threshold <10...1000>| data-
collect-interval <0...120>}
action:
Configure the actions taken to improve the wireless
network performance of clients that are connected to the Zyxel
Device supported APs. See Section 11.2.2 on page 107 for more
information on radio actions commands.
act-lock-time: Configure the length of time in seconds the
Zyxel Device cannot implement the action you set to the clients in
a poor state of wireless health. For example, if you set the time to
30, the Zyxel Device can only steer the wireless clients connected
to an AP with a poor signal to an AP with a strong signal once
even if the Zyxel Device detects that the AP is in a poor state of
wireless health more than once within 30 seconds.
act-threshold: Configure how many times the AP the clients
is connected to has to resend the packets will trigger the action
you set. For example, if you set the threshold to 10, the Zyxel
Device will steer the wireless clients to an AP with a strong signal if
the AP the clients is connected to has to try 10 times before it can
send out packets successfully.
data-collect-interval: Configure the time period over
which the client wireless health state is recorded.
To Next Page
Loading...
