ZyXEL Communications ZyWALL 310 - 65.6 File Manager Command Examples

Chapter 65 File Manager
ZyWALL Series CLI Reference Guide
546
Standby partition. The Zyxel Device reboots automatically when you upload firmware to the Running
partition.
65.6 File Manager Command Examples
These are examples of the dual firmware commands .
Table 318 File Manager Dual Firmware Commands
COMMAND DESCRIPTION
set firmware boot option <0..1>
Sets the behavior of the Zyxel Device when firmware is uploaded to
the Standby partition. (This command does not upload firmware.)
Use 0 to have the Zyxel Device reboot immediately after firmware is
uploaded to the Standby partition and become the Running
firmware. Use 1 to not have the Zyxel Device reboot immediately
after a firmware is uploaded to the Standby partition.
show firmware image boot option
Shows the behavior of the Zyxel Device when firmware is uploaded
to the Standby partition.
set firmware boot number <1..2>
Reboots the Zyxel Device immediately with firmware in partition 1 or
2. If 2 is the Standby partition, then it becomes the Running partition
after reboot. Use show version to see which partition is Standby
and which is Running.
Router(config)# set firmware boot option 0
Router(config)#
Router(config)# show firmware image boot option
boot option: 0
Router(config)#
Router(config)# set firmware boot number 2
Welcome to USG110
Username:
Terminate All Processes: OK
kill_process_and_umountfs() returns -7
Restarting system.
<snipped>
Welcome to USG110
Username: admin
Password:
Router> configure terminal
Router(config)# show version
Zyxel Communications Corp.
image number model firmware version
build date boot status
===============================================================================
1 USG110 V4.11(AAPH.0)b3s1
2015-01-11 21:53:44 Standby
2 USG110 V4.11(AAPH.0)
2015-03-13 03:47:52 Running