ZyXEL Communications ZyWALL 310 - 1.6 Shortcuts and Help; 1.6.1 List of Available Commands

Chapter 1 Command Line Interface
ZyWALL Series CLI Reference Guide
34
This is a summary of the modes.
See Chapter 49 on page 440 for more information about the user types. User users can only log in, look
at (but not run) the available commands in User mode, and log out. Limited-Admin users can look at
the configuration in the web configurator and CLI, and they can run basic diagnostics in the CLI. Admin
users can configure the Zyxel Device in the web configurator or CLI.
At the time of writing, there is not much difference between User and Privilege mode for admin users.
This is reserved for future use.
1.6 Shortcuts and Help
1.6.1 List of Available Commands
A list of valid commands can be found by typing ? or [TAB] at the command prompt. To view a list of
available commands within a command group, enter
<command> ? or <command> [TAB].
Table 3 CLI Modes
USER PRIVILEGE CONFIGURATION SUB-COMMAND
What Guest users
can do
Unable to access Unable to access Unable to access Unable to access
What User users
can do
• Look at (but not
run) available
commands
Unable to access Unable to access Unable to access
What Limited-
Admin users can
do
•Look at system
information (like
Status screen)
•Run basic
diagnostics
• Look at system
information (like
Status screen)
• Run basic
diagnostics
Unable to access Unable to access
What Admin users
can do
•Look at system
information (like
Status screen)
•Run basic
diagnostics
• Look at system
information (like
Status screen)
• Run basic
diagnostics
• Configure simple
features (such as
an address
object)
• Create or remove
complex parts
(such as an
interface)
•Configure
complex parts
(such as an
interface) in the
Zyxel Device
How you enter it Log in to the Zyxel
Device
Type enable in User
mode
Type configure
terminal in User or
Privilege mode
Type the command
used to create the
specific part in
Configuration mode
What the prompt
looks like
Router> Router# Router(config)#
(varies by part)
Router(zone)#
Router(config-
if-ge)#
...
How you exit it Type exit Type disable Type exit Type exit