Chapter 31 Web Authentication
ZyWALL Series CLI Reference Guide
254
31.2.1 web-auth login setting Sub-commands
The following table describes the sub-commands for the web-auth login setting command.
show web-auth portal
status
Displays the web portal page settings.
show web-auth status
Displays the web portal page settings.
Table 128 web-auth Commands (continued)
COMMAND DESCRIPTION
Table 129 web-auth login setting Sub-commands
COMMAND DESCRIPTION
exit
Leaves the sub-command mode.
type {external |
internal}
Sets the login page appears whenever the web portal intercepts
network traffic, preventing unauthorized users from gaining access to
the network.
internal: Use the default login page built into the Zyxel Device.
external: Use a custom login page from an external web portal
instead of the default one built into the Zyxel Device. You can
configure the look and feel of the web portal page.
Note: If you select the external option, you cannot use
endpoint security to make sure that users’ computers
meet specific security requirements before they can
access the network.
[no] error-url url
Sets the error page’s URL; for example, http://IIS server IP Address/
error.html. You can use up to 255 characters (0-9a-zA-Z;/?:@&=+$\.-
_!~'()%,) in quotes.
The
no command removes the URL.
The Internet Information Server (IIS) is the web server on which the web
portal files are installed.
[no] internal-welcome-url
url
Sets the welcome page’s URL when you select to use the default login
page built into the Zyxel Device; for example, http://IIS server IP
Address/welcome.html. You can use up to 255 characters (0-9a-zA-Z;/
?:@&=+$\.-_!~'()%,) in quotes.
The no command removes the URL.
The Internet Information Server (IIS) is the web server on which the web
portal files are installed.
[no] login-url url
Sets the login page’s URL; for example, http://IIS server IP Address/
login.html. You can use up to 255 characters (0-9a-zA-Z;/?:@&=+$\.-
_!~'()%,) in quotes.
The no command removes the URL.
The Internet Information Server (IIS) is the web server on which the web
portal files are installed.
[no] logout-ip
ipv4_address
Sets an IP address that users can use to terminate their sessions
manually by entering the IP address in the address bar of the web
browser.
The no command removes the IP address.
To Next Page
Loading...
