Chapter 65 File Manager
ZyWALL Series CLI Reference Guide
547
This example saves a back up of the current configuration before applying a shell script file.
These commands run the aaa.zysh script at noon every day, on the first day of every month, and on
every Monday, Wednesday, and Friday.
65.7 FTP File Transfer
You can use FTP to transfer files to and from the Zyxel Device for advanced maintenance and support.
65.7.1 Command Line FTP File Upload
1 Connect to the Zyxel Device.
2 Enter “bin” to set the transfer mode to binary.
3 You can upload the firmware after you log in through FTP. To upload other files, use “cd” to change to
the corresponding directory.
4 Use “put” to transfer files from the computer to the Zyxel Device.
1
For example:
In the conf directory, use "put config.conf today.conf” to upload the configuration file (config.conf) to
the Zyxel Device and rename it “today.conf”.
"put 1.00(XL.0).bin” transfers the firmware (1.00(XL.0).bin) to the Zyxel Device.
The firmware update can take up to five minutes. Do not turn off or reset
the Zyxel Device while the firmware update is in progress! If you lose
power during the firmware upload, you may need to refer to Section
65.10 on page 554 to recover the firmware.
65.7.2 Command Line FTP Configuration File Upload Example
The following example transfers a configuration file named tomorrow.conf from the computer and
saves it on the Zyxel Device as next.conf.
Router(config)# copy running-config /conf/backup.conf
Router(config)# run /script/vpn_setup.zysh
Router> configure terminal
Router(config)# schedule-run 1 aaa.zysh daily 12:00
Router(config)# schedule-run 1 aaa.zysh monthly 12:00 01
Router(config)# schedule-run 1 aaa.zysh weekly 12:00 mon wed fri
Router(config)#
1. When you upload a custom signature, the Zyxel Device appends it to the existing custom signatures stored in the
"custom.rules” file.
To Next Page
Loading...
