ZyWALL Series CLI Reference Guide
96
9.4.2 SSID and Security Profiles Example
This is an example of creating different WiFi network groups for different types of users, such as guests or
employees at your company. You can configure different SSIDs and security modes for each group.
Follow the steps below to set up a wireless network for your company guest. Use the parameters in the
table below.
1 Create an SSID profile. Set the profile name as Guest. Enter sub-command mode for this profile.
2 Set the SSID as Guest. Exit the sub-command mode.
3 Create a security profile. Set the profile name as GuestSecurity. Enter sub-command mode for this
profile.
4 Set the security mode to WPA2. Set the pre-shared key to guest123. Exit the sub-command mode.
5 Enter the Guest SSID profile sub command mode. Apply the GuestSecurity security profile to this SSID.
Table 26 SSID and Security Profiles Settings Example
GUEST
SSID Guest
Security Mode WPA2
Pre-Share Key guest123
Router# configure terminal
Router(config)# wlan-ssid-profile Guest
Router(config-wlan-ssid Guest)#
Router(config-wlan-ssid Guest)# ssid Guest
Router(config-wlan-ssid Guest)# exit
Router(config)#
Router(config)# wlan-security-profile GuestSecurity
Router(config-wlan-security GuestSecurity)#
Router(config-wlan-security GuestSecurity)# mode wpa2
Router(config-wlan-security GuestSecurity)# wpa-psk guest123
Router(config-wlan-security GuestSecurity)# exit
Router(config)#
Router(config)# wlan-ssid-profile Guest
Router(config-wlan-ssid Guest)# security GuestSecurity
To Next Page
Loading...
