Chapter 65 File Manager
ZyWALL Series CLI Reference Guide
555
Figure 46 Recovery Image Damaged
4 If “Connect a computer to port 1 and FTP to 192.168.1.1 to upload the new file” displays on the screen,
the firmware file is damaged. Use the procedure in Section 65.12 on page 557 to restore it. If the
message does not display, the firmware is OK and you do not need to use the firmware recovery
procedure.
Figure 47 Firmware Damaged
65.11 Restoring the Recovery Image
This procedure requires the Zyxel Device’s recovery image. Download the firmware package from
www.zyxel.com and unzip it. The recovery image uses a .ri extension, for example, "1.01(XL.0)C0.ri". Do
the following after you have obtained the recovery image file.
Note: You only need to use this section if you need to restore the recovery image.
1 Restart the Zyxel Device.
2 When “Press any key to enter debug mode within 3 seconds.” displays, press a key to enter debug
mode.
Figure 48 Enter Debug Mode
3 Enter atuk to initialize the recovery process. If the screen displays “ERROR”, enter atur to initialize the
recovery process.
To Next Page
Loading...
