ZyXEL Communications ZyWALL 310 - 16.2 Interface General Commands Summary; 16.2.1 Basic Interface Properties and IP Address Commands

Chapter 16 Interfaces
ZyWALL Series CLI Reference Guide
121
16.2 Interface General Commands Summary
The following table identifies the values required for many of these commands. Other input values are
discussed with the corresponding commands.
The following sections introduce commands that are supported by several types of interfaces. See
Section 16.6 on page 144 for the unique commands for each type of interface.
16.2.1 Basic Interface Properties and IP Address Commands
This table lists basic properties and IP address commands.
Table 52 Input Values for General Interface Commands
LABEL DESCRIPTION
interface_name
The name of the interface.
Ethernet interface: For some Zyxel Device models, use gex, x = 1 - N, where N equals the
highest numbered Ethernet interface for your Zyxel Device model.
For other Zyxel Device models use a name such as wan1, wan2, opt, lan1, ext-wlan, or
dmz.
virtual interface on top of Ethernet interface: add a colon (:) and the number of the virtual
interface. For example: gex:y, x = 1 - N, y = 1 - 4
VLAN interface: vlanx, x = 0 - 4094
virtual interface on top of VLAN interface: vlanx:y, x = 0 - 4094, y = 1 - 4
bridge interface: brx, x = 0 - N, where N depends on the number of bridge interfaces your
Zyxel Device model supports.
virtual interface on top of bridge interface: brx:y, x = the number of the bridge interface, y =
1 - 4
PPPoE/PPTP interface: pppx, x = 0 - N, where N depends on the number of PPPoE/PPTP
interfaces your Zyxel Device model supports.
profile_name
The name of the DHCP . You may use 1-31 alphanumeric characters, underscores(_), or
dashes (-), but the first character cannot be a number. This value is case-sensitive.
domain_name
Fully-qualified domain name. You may up to 254 alphanumeric characters, dashes (-), or
periods (.), but the first character cannot be a period.
Table 53 interface General Commands: Basic Properties and IP Address Assignment
COMMAND DESCRIPTION
show interface {ethernet | vlan |
bridge | ppp} status
Displays the connection status of the specified type of
interfaces.
show interface {interface_name |
ethernet | vlan | bridge | ppp |
virtual ethernet | virtual vlan |
virtual bridge | all}
Displays information about the specified interface, specified
type of interfaces, or all interfaces. See Section 16.6.1 on
page 147 for all possible cellular status description.
show ipv6 interface {interface_name |
all}
Displays information about the specified IPv6 interface or all
IPv6 interfaces.
show ipv6 static address interface
Displays the static IPv6 addresses configured on the specified
IPv6 interface.
show ipv6 nd ra status
config_interface
Displays the specified IPv6 interface’s IPv6 router
advertisement configuration.