Chapter 5 Registration
ZyWALL Series CLI Reference Guide
55
5.3 FaaS Commands
The following table describes the commands available for the FaaS license. You must use the
configure terminal command to enter the configuration mode before you can use these
commands.
5.3.1 Command Examples
The following command displays the account information and whether the device is registered.
show service-register status {all |
application-security | as | av | cdr |
concurrent-device-upgrade | content-
filter | firmware-upgrade | geo-ip |
idp | malware-blocker | ctdb |
managed-ap-service | pkg | reputation-
filter | sandbox | secu-reporter |
secure-wifi | sslvpn | sslvpn-status |
web-security | zymesh}
Displays the status of your service registrations.
Use all to show all registrations as a list.
Note: Options for this command might vary
depending on the Zyxel Device model and
firmware version.
show service-register status content-
filter {commtouch}
Displays Commtouch content filter service license
information.
show service-register status sslvpn-
status
Displays the status of SSL VPN tunnels.
The first number is the actual number of VPN tunnels up
and the second number is the maximum number of SSL
VPN tunnels allowed.
show service-register content-filter-
engine
Displays which external web filtering service the Zyxel
Device is set to use for content filtering.
Table 11 Command Summary: Registration (continued)
COMMAND DESCRIPTION
Table 12 Command Summary: Registration
COMMAND DESCRIPTION
show service-register status network-
essentials
Displays the status of the Zyxel Device network services,
such as security, routing and VPN.
show device-subscription status
Displays the status of the FaaS license.
Router# configure terminal
Router(config)# show device-register status
username : example
password : 123456
device register status : yes
expiration self check : no
To Next Page
Loading...
