Chapter 29 Secure Policy
ZyWALL Series CLI Reference Guide
233
3 Add HTTP, HTTPS, TELNET and SSH to the service group member list. Exit sub-command mode. Exit
configuration mode
4 Check the Zyxel Device DHCP-assigned IP address for the WAN. Use the IP address to access the Zyxel
Device from the WAN.
29.3 Session Limit Commands
The following table identifies the values required for many of these commands. Other input values are
discussed with the corresponding commands.
Router(config)# object-group service Default_Allow_WAN_To_ZyWALL
Router(group-service)#
; description no service-object
<cr> exit object-group |
Router(group-service)# service-object HTTP
Router(group-service)# service-object HTTPS
Router(group-service)# service-object TELNET
Router(group-service)# object-group SSH
Router(group-service)# exit
Router(config)# exit
Router# show interface all
No. Name Status IP Address Mask IP Assignment
===============================================================================
1 sfp Down 0.0.0.0 0.0.0.0 Static
2 wan 100M/Full XXX.XX.XX.XX 255.255.252.0 DHCP client
3 lan1 Down 192.168.1.1 255.255.255.0 Static
4 lan2 Down 192.168.2.1 255.255.255.0 Static
5 dmz Down 192.168.3.1 255.255.255.0 Static
6 opt Down 0.0.0.0 0.0.0.0 Static
Table 116 Input Values for General Session Limit Commands
LABEL DESCRIPTION
rule_number
The priority number of a session limit rule, 1 - 1000.
address_object
The name of the IP address (group) object. You may use 1-31 alphanumeric characters,
underscores (
_), or dashes (-), but the first character cannot be a number. This value is
case-sensitive.
address6_object
The name of the IPv6 address (group) object. You may use 1-31 alphanumeric
characters, underscores(
_), or dashes (-), but the first character cannot be a number. This
value is case-sensitive.
user_name
The name of a user (group). You may use 1-31 alphanumeric characters, underscores (_),
or dashes (-), but the first character cannot be a number. This value is case-sensitive.
To Next Page
Loading...
