Chapter 16 Interfaces
ZyWALL Series CLI Reference Guide
128
This example shows how to restart an interface. You can check all interface names on the Zyxel Device.
Then use either the system name or user-defined name of an interface (ge4 or Customer in this
example) to restart it.
16.2.2 IGMP Proxy Commands
Internet Group Management Protocol (IGMP) proxy is used for multicast routing. IGMP proxy enables the Zyxel
Device
to issue IGMP host messages on behalf of hosts that the Zyxel Device discovered on its IGMP-enabled
interfaces. The
Zyxel Device acts as a proxy for its hosts.
Enter configuration terminal mode and select an interface
Router> show interface-name
No. System Name User Defined Name
===========================================================================
1 ge1 ge1
2 ge2 ge2
3 ge3 ge3
4 ge4 Customer
5 ge5 ge5
Router> configure terminal
Router(config)# interface reset ge4
Router(config)# interface reset Customer
Router(config)#
Table 54 interface Commands: IGMP Proxy Commands
COMMAND DESCRIPTION
[no]igmp activate
Enables IGMP proxy on this interface.
The
no command disables IGMP proxy on this interface.
igmp direction
Sets the direction for IGMP proxy on this interface.
• downstream - enable on the interface which connects to the multicast hosts.
• upstream - enable on the interface which connects to a router running IGMP
that is closer to the multicast server
igmp version <1..3>
Sets the IGMP version to be used on this Zyxel Device interface.
To Next Page
Loading...
