ZyWALL Series CLI Reference Guide
115
CHAPTER 15
LEDs
This chapter describes two features that controls the LEDs of the managed APs connected to your Zyxel
Device - Locator and Suppression.
15.1 LED Suppression Mode
The LED Suppression feature allows you to control how the LEDs of an AP behave after it’s ready. The
default LED suppression setting of the AP is different depending on your AP model.
Note: When the AP is booting or performing firmware upgrade, the LEDs will light regardless of
the setting in LED suppression.
15.2 LED Suppression Commands
Use these commands to set how you want the LEDs to behave after the device is ready. You must use
the configure terminal command before you can use these commands.
15.2.1 LED Suppression Commands Example
The following example activates LED suppression mode on the AP with the MAC address
00:a0:c5:01:23:45 and displays the settings.
Table 46 LED Suppression Commands
COMMAND DESCRIPTION
led_suppress ap_mac_address enable
Sets the LEDs of the specified AP to turn off after it’s ready.
led_suppress ap_mac_address disable
Sets the LEDs of the specified AP to stay lit after the Zyxel
Device is ready.
show led_suppress ap_mac_address
status
Displays whether LED suppression mode is enabled or
disabled on the specified AP.
Router(config)# led_suppress 00:a0:c5:01:23:45 enable
Router(config)# show led_suppress 00:a0:c5:01:23:45 status
Suppress Mode Status : Enable
Router(config)#
To Next Page
Loading...
