Chapter 10 Rogue AP
ZyWALL Series CLI Reference Guide
103
10.4 Rogue AP Containment Commands
The following table identifies the values required for many of these commands. Other input values are
discussed with the corresponding commands.
The following table describes the commands available for rogue AP containment. You must use the
configure terminal command to enter the configuration mode before you can use these
commands.
10.4.1 Rogue AP Containment Example
This example contains the device associated with MAC address 00:13:49:11:11:12 then displays the
containment list for confirmation.
Table 33 Input Values for Rogue AP Containment Commands
LABEL DESCRIPTION
ap_mac
Specifies the MAC address (in XX:XX:XX:XX:XX:XX format) of the AP to be
contained. The no command removes the entry.
Table 34 Command Summary: Rogue AP Containment
COMMAND DESCRIPTION
rogue-ap containment
Enters sub-command mode for rogue AP
containment.
[no] activate
Activates rogue AP containment. Use the no
parameter to deactivate rogue AP containment.
[no] contain ap_mac
Isolates the device associated with the specified MAC
address. Use the no parameter to remove this device
from the containment list.
exit
Exits configuration mode for rogue AP containment.
show rogue-ap containment config
Displays whether rogue AP containment is enabled or
not.
show rogue-ap containment list
Displays the rogue AP containment list.
Router(config)# rogue-ap containment
Router(config-containment)# activate
Router(config-containment)# contain 00:13:49:11:11:12
Router(config-containment)# exit
Router(config)# show rogue-ap containment list
no. mac
=====================================================================
1 00:13:49:11:11:12
To Next Page
Loading...
