ZyXEL Communications ZyWALL 310 - Managed AP Commands; 73.1 Managed Series AP Commands Overview; 73.2 Accessing the AP CLI; 73.3 CAPWAP Client Commands

ZyWALL Series CLI Reference Guide
603
CHAPTER 73
Managed AP Commands
Connect directly to a managed AP’s CLI (Command Line Interface) to configure the managed AP’s
CAPWAP (Control And Provisioning of Wireless Access Points) client and DNS server settings.
73.1 Managed Series AP Commands Overview
Log into an AP’s CLI and use the commands in this chapter if the AP does not automatically connect to
the Zyxel Device or you need to configure the AP’s DNS server. Use the CAPWAP client commands to
configure settings to let the AP connect to the Zyxel Device. Use the DNS server commands to configure
the DNS server address to which the AP connects. When the AP reboots, it only keeps the configuration
from commands covered in this chapter.
73.2 Accessing the AP CLI
Connect to the AP’s console port and use a terminal emulation program or connect through the
network using Telnet or SSH. The settings and steps for logging in are similar to connecting to the Zyxel
Device. See Section 1.2 on page 27 for details.
Note: The AP’s default login username is admin and password is 1234. The username and
password are case-sensitive. If the AP has connected to the Zyxel Device, the AP uses
the same admin password as the Zyxel Device.
Use the write command to save the current configuration to the Zyxel Device.
Note: Always save the changes before you log out after each management session. All
unsaved changes will be lost after the system restarts.
73.3 CAPWAP Client Commands
Use the CAPWAP client commands to configure the AP’s IP address and other related management
interface settings. Do not use the original interface commands to configure the IP address and related
settings on the AP, because the AP does not save interface command settings after rebooting.