ZyXEL Communications ZyWALL 310 - 66.1.5 Console Port Logging Commands

Chapter 66 Logs
ZyWALL Series CLI Reference Guide
569
66.1.4.1 E-mail Profile Command Examples
The following commands set up e-mail log 1.
66.1.5 Console Port Logging Commands
This table lists the commands for the console port settings.
[no] logging mail <1..2> {send-log-to |
send-alerts-to} e_mail
Sets the e-mail address for logs or alerts. The no command clears the
specified field.
e_mail: You can use up to 63 alphanumeric characters,
underscores (_), or dashes (-), and you must use the @ character.
[no] logging mail <1..2> subject subject
Sets the subject line when the Zyxel Device mails to the specified e-
mail profile. The
no command clears this field.
subject: You can use up to 60 alphanumeric characters,
underscores (_), dashes (-), or
!@#$%*()+=;:’,./ characters.
[no] logging mail <1..2> category
module_name level {alert | all}
Specifies what kind of information is logged for the specified
category. The
no command disables logging for the specified
category.
[no] logging mail <1..2> schedule {full |
hourly}
Sets the e-mail schedule for the specified e-mail profile. The no
command clears the schedule field.
logging mail <1..2> schedule daily hour
<0..23> minute <0..59>
Sets a daily e-mail schedule for the specified e-mail profile.
logging mail <1..2> schedule weekly day
day hour <0..23> minute <0..59>
Sets a weekly e-mail schedule for the specified e-mail profile.
day: sun | mon | tue | wed | thu | fri | sat
[no] logging mail <1..2> tls starttls-off
Turns off STARTTLS and uses the TLS protocol for SMTP mail encryption
over TLS logging. The
no command enables the default STARTTLS
protocol.
Table 326 logging Commands: E-mail Profile Settings (continued)
COMMAND DESCRIPTION
Router# configure terminal
Router(config)# logging mail 1 address mail.zyxel.com.tw
Router(config)# logging mail 1 subject AAA
Router(config)# logging mail 1 authentication username lachang.li password
XXXXXX
Router(config)# logging mail 1 send-log-to lachang.li@zyxel.com.tw
Router(config)# logging mail 1 send-alerts-to lachang.li@zyxel.com.tw
Router(config)# logging mail 1 from lachang.li@zyxel.com.tw
Router(config)# logging mail 1 schedule weekly day mon hour 3 minute 3
Router(config)# logging mail 1
Table 327 logging Commands: Console Port Settings
COMMAND DESCRIPTION
show logging status console
Displays the current settings for the console log. (This log is not
discussed above.)
[no] logging console
Enables the console log. The no command disables the
console log.