Chapter 61 DHCPv6 Objects
ZyWALL Series CLI Reference Guide
506
CHAPTER 61
DHCPv6 Objects
This chapter describes how to configure and view DHCPv6 request and lease objects.
61.1 DHCPv6 Object Commands Summary
The following table identifies the values required for many DHCPv6 object commands. Other input
values are discussed with the corresponding commands.
The following sections list the DHCPv6 object commands.
61.1.1 DHCPv6 Object Commands
This table lists the commands for DHCPv6 objects. Use the configure terminal command to enter
the configuration mode to be able to use the commands that configure settings.
Table 287 DHCPv6 Object Command Input Values
LABEL DESCRIPTION
dhcp6_profile
The name of a DHCPv6 request object. Use a string of less than 31 characters.
interface_nam
e
The name of the interface. This depends on the Zyxel Device model.
For some models, use gex, x = 1 ~ N, where N equals the highest numbered Ethernet interface
for your Zyxel Device model.
For other models, use a name such as wan1, wan2, opt, lan1, or dmz.
Table 288 DHCPv6 Object Commands
COMMAND DESCRIPTION
show ipv6 dhcp6 binding
Displays the server side IPv6/DUID binding lease.
show dhcp6 interface
Displays all DHCPv6 server, client and relay
interfaces.
show dhcp6 lease-object [dhcp6_profile]
Displays the specified DHCPv6 lease object or all of
them.
show dhcp6 object-binding interface_name
Displays the DHCPv6 object bound to the specified
interface.
show dhcp6 request-object [dhcp6_profile]
Displays the specified DHCPv6 request object or all
of them.
dhcp6-lease-object dhcp6_profile address
ipv6_addr duid duid
Creates or edits the specified DHCP lease object
with the specified IPv6 address and DHCP Unique
IDentifier (DUID).
To Next Page
Loading...
