ZyXEL Communications ZyWALL 310 - 64.7.1 FTP Commands; 64.7.2 FTP Commands Examples

Chapter 64 System Remote Management
ZyWALL Series CLI Reference Guide
535
64.7.1 FTP Commands
The following table describes the commands available for FTP. You must use the configure
terminal
command to enter the configuration mode before you can use these commands.
64.7.2 FTP Commands Examples
This command sets a service control rule that allowed the computers with the IP addresses matching the
specified address object to access the specified zone using FTP service.
Table 309 Command Summary: FTP
COMMAND DESCRIPTION
[no] ip ftp server
Allows FTP access to the Zyxel Device. The no command disables FTP access to
the Zyxel Device.
[no] ip ftp server cert
certificate_name
Sets a certificate to be used to identify the Zyxel Device. The no command
resets the certificate used by the FTP server to the factory default.
[no] ip ftp server port
<1..65535>
Sets the FTP service port number. The no command resets the FTP service port
number to the factory default (21).
[no] ip ftp server tls-
required
Allows FTP access over TLS. The no command disables FTP access over TLS.
ip ftp server rule
{rule_number|append|ins
ert rule_number}
access-group
{ALL|address_object}
zone {ALL|zone_object}
action {accept|deny}
Sets a service control rule for FTP service.
address_object: The name of the IP address (group) object. You may use 1-31
alphanumeric characters, underscores(
_), or dashes (-), but the first character
cannot be a number. This value is case-sensitive.
zone_object: The name of the zone. For some Zyxel Device models, use up to
31 characters (a-zA-Z0-9_-). The name cannot start with a number. This value is
case-sensitive.
For other Zyxel Device models, use pre-defined zone names like DMZ, LAN1, SSL
VPN, IPSec VPN, OPT, and WAN.
ip ftp server rule move
rule_number to
rule_number
Changes the index number of a service control rule.
no ip ftp server rule
rule_number
Deletes a service control rule for FTP service.
[no] ip ftp server
cipher-suite {3des |
des | rc4}
Enables or disables the following ciphers for the FTP service: 3DES, DES, 3DES.
These ciphers are considered weak, so from firmware version 4.60 onwrads, they
are disables by default.
show ip ftp server
status
Displays FTP settings.
Router# configure terminal
Router(config)# ip ftp server rule 4 access-group Sales zone WAN action
accept