ZyXEL Communications ZyWALL 310 - 50.2.2 User Group Commands; 50.2.3 User Setting Commands

Chapter 50 User/Group
ZyWALL Series CLI Reference Guide
448
50.2.2 User Group Commands
This table lists the commands for groups.
50.2.3 User Setting Commands
This table lists the commands for user settings, except for forcing user authentication.
[no] password complexity-verify
Enforces a complex user password consisting of at
least 8 characters and at most 64. At least 1
character must be a number, at least 1 a lower case
letter, at least 1 an upper case letter and at least
one special character from the keyboard, such as
`~!@#$%^&*()_+={}|;:’<,>./\”-
The no command removes the requirement.
show pwd-expiry {all | expiration | force-
to-change-pwd | link-to-device}
Displays if a password must be changed (force-to-
change-pwd
), when a password will
expire (
expiration) and the host part of the
hyperlink in the password expiration notice email
(link-to-device).
show password complexity-verify status
Displays if a complex user password as defined
above is required.
Table 249 username/groupname Commands Summary: Users (continued)
COMMAND DESCRIPTION
Table 250 username/groupname Commands Summary: Groups
COMMAND DESCRIPTION
show groupname [groupname]
Displays information about the specified user group or about all
user groups set up in the Zyxel Device.
[no] groupname groupname
Creates the specified user group if necessary and enters sub-
command mode. The
no command deletes the specified user
group.
[no] description description
Sets the description for the specified user group. The no
command clears the description for the specified user group.
[no] groupname groupname
Adds the specified user group (second groupname) to the
specified user group (first groupname).
[no] user username
Adds the specified user to the specified user group.
groupname rename groupname
groupname
Renames the specified user group (first groupname) to the
specified group-name (second groupname).
Table 251 username/groupname Commands Summary: Settings
COMMAND DESCRIPTION
show users default-setting {all | user-
type {admin|user|guest|limited-
admin|ext-user| ext-group-user}}
Displays the default lease and reauthentication times for
the specified type of user accounts.
users default-setting [no] logon-lease-
time <0..1440>
Sets the default lease time (in minutes) for each new
user. Set it to zero to set unlimited lease time. The
no
command sets the default lease time to five.