Chapter 50 User/Group
ZyWALL Series CLI Reference Guide
447
username username logon-time-setting
<default | manual>
Sets the account to use the factory default lease
and reauthentication times or custom ones.
username username [no] logon-lease-time
<0..1440>
Sets the lease time for the specified user. Set it to
zero to set unlimited lease time. The no command
sets the lease time to five minutes (regardless of the
current default setting for new users).
username username [no] logon-re-auth-time
<0..1440>
Sets the reauthorization time for the specified user.
Set it to zero to set unlimited reauthorization time.
The
no command sets the reauthorization time to
thirty minutes (regardless of the current default
setting for new users).
username username [no] email <1..2> email-
address
Specifies up to two email addresses for a user
account. The no command removes the specified
email address for this account.
email-address: Should be in the
<user@domainname> format.
username username [no] phone phone_number
Sets the mobile phone number for the account. The
no command removes the specified mobile phone
number for this account.
phone_number: 20 character length, including
numbers 1~9 and characters +*#()-
username username vlan activate
Enables dynamic VLAN assignment for the user
account. Dynamic VLAN assignment allows you to
assign a user to a specific VLAN based on the user
credentials.
username username vlan id <1..4094>
Sets the ID number of the VLAN to which this user
account is assigned after authentication is
successful.
username username [no] {email1-
verify|email2-verify}
Sends an authorization email with a code of six
digits. The authorization email will be sent to the
email address set for the account.
_two-factor-auth-send email email user
username verification-code
verification_code
Enters the authorization code to verify your email
address for the account.
username username [no] phone-verify
Sends an SMS message with a code of six digits. The
SMS message will be sent to the mobile phone
number set for the account.
sms-service _two-factor-auth-admin-send
phone phone user username verification-code
verification_code
Enters the authorization code to verify your mobile
telephone number for the account.
[no] pwd-expiry force-to-change-pwd
activate
Enforces a periodic password change. The no
command removes the requirement.
[no] pwd-expiry expiration days <1..365>
Sets how often users must change their password
when they log into the Zyxel Device. You can
choose from once a day to once a year. The no
command removes the requirement.
pwd-expiry link-to-device custom {myrouter
| <FQDN> | <IPv6 Address> | <W.X.Y.X>}
Set the host part of the hyperlink in the password
expiration notice email. Please note that myrouter is
accessible only if the user is in the LAN of this Zyxel
Device, and there are no other Zyxel gateways in
between.
pwd-expiry expiration send-now
Sends a password expiration e-mail immediately.
Table 249 username/groupname Commands Summary: Users (continued)
COMMAND DESCRIPTION
To Next Page
Loading...
