Chapter 64 System Remote Management
ZyWALL Series CLI Reference Guide
534
64.6.1 Telnet Commands Examples
This command sets a service control rule that allowed the computers with the IP addresses matching the
specified address object to access the specified zone using Telnet service.
This command displays Telnet settings.
64.7 Configuring FTP
You can upload and download the Zyxel Device’s firmware and configuration files using FTP. To use this
feature, your computer must have an FTP client.
ip telnet server rule
{rule_number|append|ins
ert rule_number}
access-group
{ALL|address_object}
zone {ALL|zone_object}
action {accept|deny}
Sets a service control rule for Telnet service.
address_object: The name of the IP address (group) object. You may use 1-31
alphanumeric characters, underscores(
_), or dashes (-), but the first character
cannot be a number. This value is case-sensitive.
zone_object: The name of the zone. For some Zyxel Device models, use up to 31
characters (a-zA-Z0-9_-). The name cannot start with a number. This value is case-
sensitive.
For other Zyxel Device models, use pre-defined zone names like DMZ, LAN1, SSL
VPN, IPSec VPN, OPT, and WAN.
ip telnet server rule
move rule_number to
rule_number
Changes the index number of a service control rule.
no ip telnet server
rule rule_number
Deletes a service control rule for Telnet service.
show ip telnet server
status
Displays Telnet settings.
Table 308 Command Summary: Telnet (continued)
COMMAND DESCRIPTION
Router# configure terminal
Router(config)# ip telnet server rule 11 access-group RD zone LAN action
accept
Router# configure terminal
Router(config)# show ip telnet server status
active : yes
port : 23
service control:
No. Zone Address Action
========================================================================
Router(config)#
To Next Page
Loading...
