ZyXEL Communications ZyWALL 310 - 32.8 Free-Time Commands Example; 32.9 IPnP Overview; 32.10 IPnP Commands

Chapter 32 Hotspot
ZyWALL Series CLI Reference Guide
271
32.8 Free-Time Commands Example
The following example enables the free time feature and sets the Zyxel Device to provide user account
information in the web screen and also sent account information via SMS text messages. It then displays
the free time settings.
32.9 IPnP Overview
IP Plug and Play (IPnP) allows a computer to access the Internet without changing the network settings
(such as IP address and subnet mask) of the computer, even when the IP addresses of the computer
and the Zyxel Device are not in the same subnet.
When you disable the IPnP feature, only computers with dynamic IP addresses or static IP addresses in
the same subnet as the Zyxel Device’s LAN IP address can connect to the Zyxel Device or access the
Internet through the Zyxel Device.
The IPnP feature does not apply to a computer using either a dynamic IP address or a static IP address
that is in the same subnet as the Zyxel Device's IP address.
Note: You must enable NAT to use the IPnP feature.
32.10 IPnP Commands
The following table lists the ipnp commands. You must use the configure terminal command to
enter the configuration mode before you can use these commands.
Router# configure terminal
Router(config)# free-time activate
Router(config)# free-time deliver-method onscreen
Router(config)# free-time deliver-method sms
Router(config)# show free-time status
Activate: yes
Time Period: 30
Reset Time: 00:00
Maximum registration number before reset time: 1
Delivery Method: onscreen-sms
Router(config)#
Table 141 ipnp Commands
COMMAND DESCRIPTION
[no] ip ipnp activate
Enables IPnP on the Zyxel Device. The no command disables IPnP.
ip ipnp config
Enters the IPnP sub-command mode to enable IPnP on specific internal
interface(s).
[no] interface interface_name
Enables IPnP on a specific internal interface. The no command disables IPnP for
the specified interface.