ZyXEL Communications ZyWALL 310 - 42.2 General IDP Commands; 42.2.1 IDP Activation

Chapter 42 IDP Commands
ZyWALL Series CLI Reference Guide
350
Figure 32 Rate Based Signatures Example
Note: The no command negates the action or returns it to the default value.
The following table lists valid input for IDP commands.
42.2 General IDP Commands
42.2.1 IDP Activation
Note: You must register for the IDP/AppPatrol signature service (at least the trial) before you
can use it. See Chapter 5 on page 53.
This table shows the IDP signature, and system-protect activation commands.
Table 191 Input Values for IDP Commands
LABEL DESCRIPTION
zone_profile
The name of a zone. For some Zyxel Device models, use up to 31 characters (a-zA-Z0-9_-). The
name cannot start with a number. This value is case-sensitive.
For other Zyxel Device models, use pre-defined zone names like DMZ, LAN1, SSL VPN, IPSec
VPN, OPT, and WAN.
idp_profile
The name of an IDP profile. It can consist of alphanumeric characters, the underscore, and
the dash, and it is 1-31 characters long. Spaces are not allowed.
Table 192 IDP Activation
COMMAND DESCRIPTION
[no] security-service ips
activate
Turns on IDP on the Zyxel Device.
The no command disables IDP.
show security-service
status
Displays whether the security services such as IDP are enabled on the Zyxel
Device.