Chapter 66 Logs
ZyWALL Series CLI Reference Guide
566
66.1.2.1 System Log Command Examples
The following command displays the current status of the system log.
66.1.3 Debug Log Commands
This table lists the commands for the debug log settings.
[no] logging usb-storage keep-
duration
Sets a limit on how long log files are stored on the USB storage device, before
being automatically deleted. This helps prevent the storage device from
running out of space.
The
[no] command removes the limit, meaning log files are stored forever.
logging usb-storage keep-duration
day <1..365>
Sets how long, in days, that log files are kept on the USB storage device before
being automatically deleted.
Table 322 logging Commands: System Log Settings (continued)
COMMAND DESCRIPTION
Router# configure terminal
Router(config)# show logging status system-log
512 events logged
suppression active : yes
suppression interval: 10
category settings :
content-filter : normal , forward-web-sites : no ,
blocked-web-sites : normal , user : normal ,
myZyxel.com : normal , zysh : normal ,
idp : normal , app-patrol : normal ,
ike : normal , ipsec : normal ,
firewall : normal , sessions-limit : normal ,
policy-route : normal , built-in-service : normal ,
system : normal , connectivity-check: normal ,
device-ha : normal , routing-protocol : normal ,
nat : normal , pki : normal ,
interface : normal , interface-statistics: no ,
account : normal , port-grouping : normal ,
force-auth : normal , l2tp-over-ipsec : normal ,
anti-virus : normal , white-list : normal ,
black-list : normal , ssl-vpn : normal ,
cnm : normal , traffic-log : no ,
file-manage : normal , dial-in : normal ,
adp : normal , default : all ,
Table 323 logging Commands: Debug Log Settings
COMMAND DESCRIPTION
show logging debug status
Displays the current settings for the debug log.
show logging debug entries [priority pri]
[category module_name] [srcip ip] [srcip6
ipv6_addr] [dstip ip] [dstip6 ipv6_addr]
[service service_name] [srciface
interface_name] [dstiface interface_name]
[protocol protocol] [begin <1..512> end
<1..512>] [keyword keyword]
Displays the specified entries in the system log.
pri: alert | crit | debug | emerg | error | info | notice | warn
keyword: You can use alphanumeric and
()+/:=?!*#@$_%-
characters, and it can be up to 63 characters long. This searches
the message, source, destination, and notes fields.
To Next Page
Loading...
