ZyXEL Communications ZyWALL 310 - Page 567

Chapter 66 Logs
ZyWALL Series CLI Reference Guide
567
This table lists the commands for the remote syslog server settings. For the purposes of this device’s CLI,
Access Points are referred to as WTPs
.
This table lists the commands for setting how often to send information to the VRPT (Zyxel’s Vantage
Report) server.
show logging debug entries field field
[begin <1..1024> end <1..1024>]
Displays the specified field in the debug log.
field: time | msg | src | dst | note | pri | cat | all
[no] logging debug suppression
Enables log consolidation in the debug log. The no command
disables log consolidation in the debug log.
[no] logging debug suppression interval
<10..600>
Sets the log consolidation interval for the debug log. The no
command sets the interval to ten.
clear logging debug buffer
Clears the debug log.
Table 323 logging Commands: Debug Log Settings (continued)
COMMAND DESCRIPTION
Table 324 logging Commands: Remote Syslog Server Settings
COMMAND DESCRIPTION
show logging status syslog
Displays the current settings for the remote servers.
[no] logging syslog <1..4>
Enables the specified remote server. The no command
disables the specified remote server.
[no] logging syslog <1..4> address {ip |
hostname}
Sets the URL or IP address of the specified remote server. The
no command clears this field.
hostname: You may up to 63 alphanumeric characters,
dashes (-), or periods (.), but the first character cannot be a
period.
[no] logging syslog <1..4> {disable | level
normal | level all}
Specifies what kind of information, if any, is logged for the
specified category.
[no] logging syslog <1..4> facility {local_1 |
local_2 | local_3 | local_4 | local_5 | local_6
| local_7}
Sets the log facility for the specified remote server. The no
command sets the facility to local_1.
[no] logging syslog <1..4> format {cef | vrpt}
Sets the format of the log information.
cef: Common Event Format, syslog-compatible format.
vrpt: Zyxel’s Vantage Report, syslog-compatible format.
Table 325 logging Commands: VRPT Settings
COMMAND DESCRIPTION
vrpt send device information interval
<15..3600>
Sets the interval (in seconds) for how often the Zyxel Device
sends a device information log to the VRPT server.
vrpt send interface statistics interval
<15..3600>
Sets the interval (in seconds) for how often the Zyxel Device
sends an interface statistics log to the VRPT server.
vrpt send system status interval <15..3600>
Sets the interval (in seconds) for how often the Zyxel Device
sends a system status log to the VRPT server.
show vrpt send device information interval
Displays the interval (in seconds) for how often the Zyxel Device
sends a device information log to the VRPT server.
show vrpt send interface statistics interval
Displays the interval (in seconds) for how often the Zyxel Device
sends an interface statistics log to the VRPT server.