ZyXEL Communications ZyWALL 310 - 33.2 IPSec VPN Commands Summary

Chapter 33 IPSec VPN
ZyWALL Series CLI Reference Guide
277
Figure 27 VPN: IKE SA and IPSec SA
In this example, a computer in network A is exchanging data with a computer in network B. Inside
networks A and B, the data is transmitted the same way data is normally transmitted in the networks.
Between routers X and Y, the data is protected by tunneling, encryption, authentication, and other
security features of the IPSec SA. The IPSec SA is secure because routers X and Y established the IKE SA
first.
33.2 IPSec VPN Commands Summary
The following table describes the values required for many IPSec VPN commands. Other values are
discussed with the corresponding commands.
Table 146 Input Values for IPSec VPN Commands
LABEL DESCRIPTION
profile_name
The name of a VPN concentrator. You may use 1-31 alphanumeric characters,
underscores(
_), or dashes (-), but the first character cannot be a number. This value is
case-sensitive.
policy_name
The name of an IKE SA. You may use 1-31 alphanumeric characters, underscores(_), or
dashes (-), but the first character cannot be a number. This value is case-sensitive.
map_name
The name of an IPSec SA. You may use 1-31 alphanumeric characters, underscores(_), or
dashes (-), but the first character cannot be a number. This value is case-sensitive.
domain_name
Fully-qualified domain name. You may use up to 254 alphanumeric characters, dashes (-),
or periods (.), but the first character cannot be a period.
e_mail
An e-mail address. You can use up to 63 alphanumeric characters, underscores (_),
dashes (-), or @ characters.
distinguished_na
me
A domain name. You can use up to 511 alphanumeric, characters, spaces, or .@=,_-
characters.