ZyXEL Communications ZyWALL 310 - 23.2.1 HTTP Redirect Command Examples

Chapter 23 HTTP Redirect
ZyWALL Series CLI Reference Guide
206
The following table describes the commands available for HTTP redirection. You must use the
configure terminal command to enter the configuration mode before you can use these
commands.
23.2.1 HTTP Redirect Command Examples
The following commands create a HTTP redirect rule, disable it and display the settings.
Table 104 Command Summary: HTTP Redirect
COMMAND DESCRIPTION
ip http-redirect description interface
interface_name redirect-to w.x.y.z
<1..65535>
Sets a HTTP redirect rule.
ip http-redirect description interface
interface_name redirect-to w.x.y.z
<1..65535> deactivate
Disables a HTTP redirect rule.
ip http-redirect activate description
Enables a rule with the specified rule name.
ip http-redirect deactivate description
Disables a rule with the specified rule name.
no ip http-redirect description
Removes a rule with the specified rule name.
ip http-redirect flush
Clears all HTTP redirect rules.
show ip http-redirect [description]
Displays HTTP redirect settings.
Router# configure terminal
Router(config)# ip http-redirect example1 interface ge1 redirect-to
10.10.2.3 80
Router(config)# ip http-redirect example1 interface ge1 redirect-to
10.10.2.3 80 deactivate
Router(config)# show ip http-redirect
Name Interface Proxy Server Port Active
===========================================================================
example1 ge1 10.10.2.3 80 no