Chapter 71 Maintenance Tools
ZyWALL Series CLI Reference Guide
594
71.3 Configuration File Backup
You can back up the Zyxel Device’s configuration file, by downloading it to your local computer or by sending it to
an email address.
device-ha2 schedule-reboot check-
timeout <1..3600>
Sets how long the active device pings the passive device for, in
seconds, after the passive device has restarted. If the passive
device does not respond within the specified time, the activate
device cancels the scheduled reboot.
The default time is 1800 seconds.
device-ha2 schedule-reboot delay
<1..300>
Sets a delay time to ensure the passive device has sufficient time
to shut down and start up. The delay time is measured in
seconds, and the default is 10.
After the passive device shuts down, the active device waits for
the specified delay time before starting to ping the passive
device. Then after the ping is successful, the activate device
waits for the specified delay time before rebooting.
show schedule reboot status
Displays the status of the reboot schedule, including whether it is
active and at what time and date the device is scheduled to
reboot.
show device-ha2 schedule-reboot
check-timeout
Displays the ping timeout time, in seconds.
show device-ha2 schedule-reboot
delay
Displays the HA reboot delay time, in seconds.
Table 340 Scheduled Reboot Commands (continued)
COMMAND DESCRIPTION
Table 341 Configuration File Backup Commands
COMMAND DESCRIPTION
The conf-mail commands send a user-specified configuration file immediately to an
email address.
conf-mail mail-subject <subject>
Sets the backup email subject text.
The text must be 1–60 characters, and may consist of letters,
numbers, and the following special characters: ‘()+,./
:=?;!*#@$_%-
conf-mail mail-content <mail-
content>
Sets the backup email body text.
The text must consist of 1–250 ASCII characters.
conf-mail no mail-content
Clears the backup email body text.
conf-mail {mail-to-1|mail-to-
2|mail-to-3|mail-to-4|mail-to-5}
<user@domainname>
Sets the receiving email address.
You can send the configuration file to a maximum of five email
addresses.
conf-mail no {mail-to-1|mail-to-
2|mail-to-3|mail-to-4|mail-to-5}
Clears the receiving email address.
conf-mail attach password
<attachment password>
Adds an encryption password to the configuration file in the
email.
The password must consist of 1–31 ASCII characters.
To Next Page
Loading...
