ZyXEL Communications ZyWALL 310 - 9.5 MAC Filter Profile Commands; 9.5.1 MAC Filter Profile Example

Chapter 9 Wireless LAN Profiles
ZyWALL Series CLI Reference Guide
97
9.5 MAC Filter Profile Commands
The following table identifies the values required for many of these commands. Other input values are
discussed with the corresponding commands.
The following table describes the commands available for security profile management. You must use
the
configure terminal command to enter the configuration mode before you can use these
commands.
9.5.1 MAC Filter Profile Example
The following example creates a MAC filter profile with the name ‘MACFILTER01’.
Table 27 Input Values for General MAC Filter Profile Commands
LABEL DESCRIPTION
macfilter_profile_name
The MAC filter profile name. You may use 1-31 alphanumeric characters,
underscores (
_), or dashes (-), but the first character cannot be a number. This
value is case-sensitive.
description2
Sets the description of the profile. You may use up to 60 alphanumeric
characters, underscores (
_), or dashes (-). This value is case-sensitive.
Table 28 Command Summary: MAC Filter Profile
COMMAND DESCRIPTION
show wlan-macfilter-profile {all |
macfilter_profile_name}
Displays the security profile(s).
all: Displays all profiles for the selected operating mode.
macfilter_profile_name: Displays the specified profile
for the selected operating mode.
wlan-macfilter-profile rename
macfilter_profile_name1
macfilter_profile_name2
Gives an existing security profile
(macfilter_profile_name1) a new name
(macfilter_profile_name2).
[no] wlan-macfilter-profile
macfilter_profile_name
Enters configuration mode for the specified MAC filter profile.
Use the no parameter to remove the specified profile.
filter-action {allow | deny} Permits the wireless client with the MAC addresses in this
profile to connect to the network through the associated SSID;
select deny to block the wireless clients with the specified MAC
addresses.
The default is set to deny.
[no] sta_mac description
description2
Sets the description of the wireless client with this MAC
address. Enter up to 60 characters. Spaces and underscores
allowed.
exit Exits configuration mode for this profile.
Router(config)# wlan-macfilter-profile MACFILTER01
Router(config-macfilter-profile)# filter-action deny
Router(config-macfilter-profile)# 01:02:03:04:05:06 description MAC01
Router(config-macfilter-profile)# 01:02:03:04:05:07 description MAC02
Router(config-macfilter-profile)# 01:02:03:04:05:08 description MAC03
Router(config-macfilter-profile)# exit
Router(config)#