ZyXEL Communications ZyWALL 310 - 20.2.1 Zone Command Examples

Chapter 20 Zones
ZyWALL Series CLI Reference Guide
188
20.2.1 Zone Command Examples
The following commands add Ethernet interfaces ge1 and ge2 to zone A.
Router# configure terminal
Router(config)# zone A
Router(zone)# interface ge1
Router(zone)# interface ge2
Router(zone)# exit
Router(config)# show zone
No. Name Member
===========================================================================
1 A ge1,ge2
Router(config)# show zone A
No. Type Member
===========================================================================
1 interface ge1
2 interface ge2