ZyXEL Communications ZyWALL 310 - 16.9.1 VLAN Interface Command Examples; 16.10 Bridge Specific Commands

Chapter 16 Interfaces
ZyWALL Series CLI Reference Guide
156
This table lists the VLAN interface commands.
16.9.1 VLAN Interface Command Examples
The following commands show you how to set up VLAN vlan100 with the following parameters: VLAN ID
100, interface ge1, IP 1.2.3.4, subnet 255.255.255.0, MTU 598, gateway 2.2.2.2, description "I am vlan100”,
upstream bandwidth 345, and downstream bandwidth 123.
16.10 Bridge Specific Commands
This section covers commands that are specific to bridge interfaces. Bridge interfaces also use many of
the general interface commands discussed at the beginning of Section 16.2 on page 121.
The following table identifies the values required for many of these commands. Other input values are
discussed with the corresponding commands.
Table 72 interface Commands: VLAN Interfaces
COMMAND DESCRIPTION
interface interface_name
Creates the specified interface if necessary and enters sub-command mode.
[no] port
interface_name
Specifies the Ethernet interface on which the VLAN interface runs. The no command clears
the port.
[no] vlan-id <1..4094>
Specifies the VLAN ID used to identify the VLAN. The no command clears the VLAN ID.
[no] priority-code
<0..7.
Sets the 802.1p priority for vlan outgoing traffic from 0 to 7 where 0 is the lowest priority
(lowest, background traffic) and 7 the highest (network control traffic).
show port vlan-id
Displays the Ethernet interface VLAN settings.
Router# configure terminal
Router(config)# interface vlan100
Router(config-if-vlan)# vlan-id 100
Router(config-if-vlan)# port ge1
Router(config-if-vlan)# ip address 1.2.3.4 255.255.255.0
Router(config-if-vlan)# ip gateway 2.2.2.2
Router(config-if-vlan)# mtu 598
Router(config-if-vlan)# upstream 345
Router(config-if-vlan)# downstream 123
Router(config-if-vlan)# description I am vlan100
Router(config-if-vlan)# exit
Table 73 Input Values for Bridge Interface Commands
LABEL DESCRIPTION
interface_name
The name of the interface.
Ethernet interface: For some Zyxel Device models use gex, x = 1 - N, where N equals the
highest numbered Ethernet interface for your Zyxel Device model.
For other Zyxel Device models use a name such as wan1, wan2, opt, lan1, ext-wlan, or
dmz.
VLAN interface: vlanx, x = 0 - 4094
bridge interface: brx, x = 0 - N, where N depends on the number of bridge interfaces your
Zyxel Device model supports.