Chapter 16 Interfaces
ZyWALL Series CLI Reference Guide
147
16.6.1 Cellular Status
The following table describes the different kinds of cellular connection status on the Zyxel Device.
no budget log-percentage
Sets the Zyxel Device to not create a log when the set
percentage of time budget or data limit is exceeded. You
can configure the percentage using the budget
percentage command.
connectivity {nail-up | dial-on-
demand}
Sets the connection to be always on or only when there is
traffic.
[no] local-address <ip>
Sets (or clears) the cellular interface’s local (own) IP
address.
mtu <576..1492>
Sets the Maximum Transmission Unit in bytes.
[no] pin <pin code>
Sets (or clears) the PIN code for the cellular device’s 3G
card. Use 1-4 alphanumeric characters, underscores(
_), or
dashes (-).
[no] remote-address <ip>
Sets (or clears) the IP address of the cellular interface’s
peer (like a gateway or PPPoE server).
interface cellular budget-auto-save
<5..1440>
Sets how often (in minutes) the Zyxel Device saves time
and data usage records for a connection using the 3G
card.
show interface cellular
[corresponding-slot|device-
status|support-device]
Shows the status of the specified cellular interface.
show interface cellular corresponding-
slot
Shows which cellular interface is on which slot and
whether which cellular interface has been configured.
show interface cellular device-status
Displays the installed SIM card and 3G card status.
show interface cellular support-device
Displays all 3G card models the Zyxel Device can support.
show interface cellular budget-auto-
save
Displays how often (in minutes) the Zyxel Device records
time and data usage of your 3G budgets.
show interface cellular status
Displays the traffic statistics and connection status for your
cellular interfaces. See Section 16.6.1 on page 147 for all
possible cellular status descriptions.
show interface interface_name [budget]
Displays the budget control settings for the specified
cellular interface.
show interface interface_name device
status
Displays the 3G card and SIM card information for the
specified cellular interface.
show interface interface_name device
profile
Displays the 3G connection profile settings of the specified
cellular interface.
Table 66 Interface Cellular Commands (continued)
COMMAND DESCRIPTION
Table 67 Cellular Status
STATUS DESCRIPTION
No device no 3G device is connected to the Zyxel Device.
No service no 3G network is available in the area; you cannot connect to the Internet.
Limited service returned by the service provider in cases where the SIM card is expired, the user failed to
pay for the service and so on; you cannot connect to the Internet.
Device detected displays when you connect a 3G device.
To Next Page
Loading...
