Chapter 16 Interfaces
ZyWALL Series CLI Reference Guide
146
[no] budget data active {download-
upload|download|upload}
<1..100000>
Sets how much downstream and/or upstream data (in
Mega bytes) can be transmitted via the 3G connection
within one month.
download: set a limit on the downstream traffic (from the
ISP to the Zyxel Device).
upload: set a limit on the upstream traffic (from the Zyxel
Device to the ISP).
download-upload: set a limit on the total traffic in both
directions.
If you change the value, the Zyxel Device resets the
statistics.
Use the no command to disable data budget control.
budget reset-day <0..31>
Sets the date on which the Zyxel Device resets the budget
every month. If the date you selected is not available in a
month, such as 30th or 31st, the Zyxel Device resets the
budget on the last day of the month.
budget reset-counters
Resets the time and data budgets immediately. The count
starts over with the 3G connection’s full configured
monthly time and data budgets. This does not affect the
normal monthly budget restart.
budget {log|log-alert}[recursive
<1..65535>]
Sets the Zyxel Device to create a log (log) or an alert log
(log-alert) when the time or data limit is exceeded. You
can also specify how often (from 1 to 65535 minutes) to
generate a log or an alert.
no budget log
Sets the Zyxel Device to not create a log when the time or
data limit is exceeded.
budget new-connection
{allow|disallow}
Sets to permit (allow) or drop/block (disallow) new 3G
connections when the time or data limit is exceeded.
budget current-connection
{keep|drop}
Sets to maintain the existing 3G connection (keep) or
disconnect it (drop) when the time or data limit is
exceeded. You cannot set budget new-connection to
allow and budget current-connection to drop at the
same time.
If you set budget new-connection to disallow and budget
current-connection to keep, the Zyxel Device allows you
to transmit data using the current connection, but you
cannot build a new connection if the existing connection
is disconnected.
budget percentage {ptime|pdata}
<0..99>
Sets a percentage (0~99) of time budget (ptime) or data
(pdata) limit. When the specified limit is exceeded, the
Zyxel Device takes the action configured using the budget
{log-percentage|log-percentage-alert} command.
budget {log-percentage|log-
percentage-alert} [recursive
<1..65535>]
Sets to have the Zyxel Device create a log (log-
percentage) or an alert log (log-percentage-alert)
when the set percentage of time budget or data limit is
exceeded. You can configure the percentage using the
budget percentage command.
You can also set how often (from 1 to 65535 minutes) to
send the log or alert.
Table 66 Interface Cellular Commands (continued)
COMMAND DESCRIPTION
To Next Page
Loading...
