Chapter 18 Route
ZyWALL Series CLI Reference Guide
177
Figure 18 Example of Static Routing Topology
18.4 Static Route Commands
The following table describes the commands available for static route. You must use the configure
terminal
command to enter the configuration mode before you can use these commands. See
Section Table 81 on page 170 for information on input values.
Table 84 Command Summary: Static Route
COMMAND DESCRIPTION
[no] ip route {w.x.y.z} {w.x.y.z}
{interface|w.x.y.z} <0..127>
Sets a static route. The no command deletes a static
route.
ip route replace {w.x.y.z} {w.x.y.z}
{interface|w.x.y.z} <0..127> with {w.x.y.z}
{w.x.y.z} {interface|w.x.y.z} <0..127>
Changes an existing route’s settings.
show ip route-settings
Displays static route information. Use show ip route to
see learned route information. See Section 19.2.5 on
page 182.
ip6 route destv6/prefix { ipv6_global_address |
ipv6_link_local | interface} [<0..127>]
Sets an IPv6 static route.
ip6 route destv6/prefix { ipv6_link_local
interface} [<0..127>]
Sets an IPv6 link local static route.
no ip6 route destv6/prefix { gatewayv6 | interface}
[<0..127>]
Deletes the specified IPv6 static route.
ip6 route replace destv6/prefix { gatewayv6 |
interface} [<0..127>] with destv6/prefix {
gatewayv6 | interface} [<0..127>]
Changes an existing IPv6 route’s settings.
[no] ip route control-virtual-server-rules
activate
Gives static routes priority over NAT virtual server rules (1-
1 SNAT). It also automatically gives policy routes priority
over NAT virtual server rules. Use the no command to
give NAT virtual server rules priority over static routes.
show ip route control-virtual-server-rules
Displays whether or not static routes have priority over
NAT virtual server rules (1-1 SNAT).
To Next Page
Loading...
