ZyXEL Communications ZyWALL 310 - 24.3 Redirect Commands

Chapter 24 Redirect Service
ZyWALL Series CLI Reference Guide
208
24.3 Redirect Commands
The following table identifies the values required for many of these commands. Other input values are
discussed with the corresponding commands.
The following table describes the commands available for HTTP redirection. You must use the
configure terminal command to enter the configuration mode before you can use these
commands.
Table 105 Input Values for HTTP Redirect Commands
LABEL DESCRIPTION
profile_name
The name to identify the rule. You may use 1-31 alphanumeric characters, underscores(_),
or dashes (-), but the first character cannot be a number. This value is case-sensitive.
interface_name
The name of the interface.
Ethernet interface: For some Zyxel Device models, use gex, x = 1 - N, where N equals the
highest numbered Ethernet interface for your Zyxel Device model.
For other Zyxel Device models use a name such as wan1, wan2, opt, lan1, or dmz.
virtual interface on top of Ethernet interface: add a colon (:) and the number of the virtual
interface. For example: gex:y, x = 1 - N, y = 1 - 4
VLAN interface: vlanx, x = 0 - 4094
virtual interface on top of VLAN interface: vlanx:y, x = 0 - 4094, y = 1 - 4
bridge interface: brx, x = 0 - N, where N depends on the number of bridge interfaces your
Zyxel Device model supports.
virtual interface on top of bridge interface: brx:y, x = the number of the bridge interface, y
= 1 - 4
PPPoE/PPTP interface: pppx, x = 0 - N, where N depends on the number of PPPoE/PPTP
interfaces your Zyxel Device model supports.
user_name
This is the user account or user group name to which this rule is applied.
Table 106 Command Summary: Redirect
COMMAND DESCRIPTION
redirect-service append <1..20>
Adds a new Redirect rule and enters sub-command
mode.
redirect-service <1..20>
Edits an existing Redirect rule and enters sub-command
mode.
[no] activate
Enables the Redirect rule.
The no command disables the Redirect rule.
exit
Leaves sub-command mode
[no] interface interface_name
Names the interface for the Redirect rule.
The no command restores the interface to any.
[no] name profile_name
Names the Redirect rule to identify it.
The no command restores the name to default.
[no] port <1..65535>
Sets the service port for the Redirect rule.
The no command restores the http-redirect port to 80,
and the smtp-redirect port to 25.