Chapter 63 System
ZyWALL Series CLI Reference Guide
520
63.7.1 Authentication Server Commands
The following table lists the authentication server commands you use to configure the Zyxel Device’s
built-in authentication server settings.
Table 297 Command Summary: Authentication Server
COMMAND DESCRIPTION
[no] auth-server activate
Sets the Zyxel Device to act as an authentication server for other RADIUS
clients, such as APs. The
no command sets the Zyxel Device to not act
as an authentication server for other APs.
auth-server authentication
auth_method
Specifies an authentication method used by the authentication server.
no auth-server authentication
Resets the authentication method used by the authentication server to
the factory default (
default).
[no] auth-server cert
certificate_name
Specifies a certificate used by the authentication server (Zyxel Device).
The
no command resets the certificate used by the authentication
server to the factory default (
default).
certificate_name: The name of the certificate. You can use up to 31
alphanumeric and ;‘~!@#$%^&()_+[]{}’,.=-
characters.
[no] auth-server trusted-
client profile_name
Creates a trusted RADIUS client profile. The no command deletes the
specified profile.
profile-name: You may use 1-31 alphanumeric characters,
underscores(
_), or dashes (-), but the first character cannot be a
number. This value is case-sensitive.
[no] activate
Enables the client profile. The no command disables the profile.
[no] ip address ip
subnet_mask
Sets the client’s IP address and subnet mask. The no command clears
this setting.
[no] secret secret
Sets a password as the key to be shared between the Zyxel Device and
the client. The
no command clears this setting.
[no] description
description
Sets the description for the profile. The no command clears this setting.
description: You can use alphanumeric and
()+/:=?!*#@$_%-
characters, and it can be up to 60 characters long.
show auth-server status
Displays the Zyxel Device’s authentication server settings.
show auth-server trusted-
client
Displays all RADIUS client profile settings.
show auth-server trusted-
client profile_name
Displays the specified RADIUS client profile settings.
To Next Page
Loading...
