ZyXEL Communications ZyWALL 310 - 31.3.3 Command Setup Sequence Example; 31.3.4 Two-Factor Web Authentication Command Example

Chapter 31 Web Authentication
ZyWALL Series CLI Reference Guide
259
31.3.3 Command Setup Sequence Example
The following commands show how to configure the Zyxel Device to communicate with an an SSO
agent at IP address ‘1.1.1.1’, using port ‘2158’ and preshared key ‘12345678’.
31.3.4 Two-Factor Web Authentication Command Example
The following example shows how to enable web authentication with two-factor authentication for
clients on LAN1, and then configure Google Authenticator for a user account.
Router(config)# sso agent primary
Router(config-sso-primary)# ip 1.1.1.1
Router(config-sso-primary)# port 2158
Router(config-sso-primary)# exit
Router(config)# sso presharekey 12345678
Router(config)# sso port 2158
Router(config)# exit
Router# show sso agent
Agent: primary
IP Address: 1.1.1.1
Port: 2158
Agent: secondary
IP Address:
Port: 0
Router# show sso agent primary
Agent: primary
IP Address: 1.1.1.1
Port: 2158
Router# show sso agent secondary
Agent: secondary
IP Address:
Port: 0
Router# show sso agent status
ZySSO Primary Agent: Offline
ZySSO Primary Agent: Offline
Router# show sso port
ZySSO port: 2158
Router# show sso presharekey
ZySSO presharekey: 12345678
Router#