Chapter 19 Routing Protocol
ZyWALL Series CLI Reference Guide
180
19.2.1 RIP Commands
This table lists the commands for RIP.
19.2.2 General OSPF Commands
This table lists the commands for general OSPF configuration.
Table 87 router Commands: RIP
COMMAND DESCRIPTION
router rip
Enters sub-command mode.
[no] network interface_name
Enables RIP on the specified Ethernet interface. The no
command disables RIP on the specified interface.
[no] redistribute {static | ospf}
Enables redistribution of routing information learned from the
specified source. The
no command disables redistribution
from the specified source.
redistribute {static | ospf} metric
<0..16>
Sets the metric when redistributing routing information learned
from the specified source.
[no] version <1..2>
Sets the default RIP version for all interfaces with RIP enabled. If
the interface RIP version is blank, the interface uses the default
version. This is not available in the GUI. The
no command sets
the default RIP version to 2.
[no] passive-interface interface_name
Sets the direction to “In-Only” for the specified interface. The
no command sets the direction to bi-directional.
[no] authentication mode {md5 | text}
Sets the authentication mode for RIP. The no command sets
the authentication mode to “none”.
[no] authentication string authkey
Sets the password for text authentication. The no command
clears the password.
authentication key <1..255> key-string
authkey
Sets the MD5 ID and password for MD5 authentication.
no authentication key
Clears the MD5 ID and password.
[no] outonly-interface interface_name
Sets the direction to “Out-Only” for the specified interface. The
no command sets the direction to “BiDir”.
encrypted-string ciphertext
Sets the cipher to encrypt the string.
Table 88 router Commands: General OSPF Configuration
COMMAND DESCRIPTION
router ospf
Enters sub-command mode.
[no] redistribute {static | rip}
Enables redistribution of routing information learned from the specified
non-OSPF source. The
no command disables redistribution from the
specified non-OSPF source.
[no] redistribute {static | rip}
metric-type <1..2> metric
<0..16777214>
Sets the metric for routing information learned from the specified non-
OSPF source. The
no command clears the metric.
[no] passive-interface
interface_name
Sets the direction to “In-Only” for the specified interface. The no
command sets the direction to “BiDir”.
[no] router-id IP
Sets the 32-bit ID (in IP address format) of the Zyxel Device. The no
command resets it to “default”, or the highest available IP address.
To Next Page
Loading...
