Chapter 36 Bandwidth Management
ZyWALL Series CLI Reference Guide
308
36.2.1 Bandwidth Sub-Commands
The following table describes the sub-commands for several bwm commands.
[no] bwm highest sip bandwidth
priority
Maximizes the throughput of SIP traffic to improve SIP-based VoIP call sound
quality. This has the Zyxel Device immediately send SIP traffic upon identifying it.
When this option is enabled the Zyxel Device ignores any other application
patrol rules for SIP traffic (so there is no bandwidth control for SIP traffic) and
does not record SIP traffic bandwidth usage statistics.
The
[no]command clears this setting.
bwm insert <1..127>
Enters the config-bwm sub-command mode to add a policy before the
specified policy number. See Table 163 on page 308 for the sub-commands.
bwm <1..127>
Enters the config-bwm sub-command mode to create a bandwidth
management policy. See Table 163 on page 308 for the sub-commands.
bwm modify <1..127>
Enters the config-bwm sub-command mode to edit a bandwidth management
policy. See Table 163 on page 308 for the sub-commands.
bwm move <1..127> to <1..127>
Moves a policy to the number that you specified.
show bwm activation
Displays whether bandwidth management is enabled.
show bwm all
Displays all bandwidth management policies.
show bwm applications list
Displays all applications supported by bandwidth management.
show bwm default
Displays the default bandwidth management policy.
show bwm highest sip bandwidth
priority
Displays whether the Zyxel Device is set maximize the throughput of SIP traffic to
improve SIP-based VoIP call sound quality.
Table 162 bwm Commands (continued)
COMMAND DESCRIPTION
Table 163 bwm Sub-commands
COMMAND DESCRIPTION
[no] activate
Enables a policy. The no command disables the policy.
[no] description description
Sets a descriptive name (up to 60 printable ASCII characters)
for a policy.
The no command removes the descriptive name from the
policy.
[no] destination address_object
Sets the destination IP address or address group for whom this
policy applies.
The no command resets the destination IP address(es) to the
default (any). any
means all IP addresses.
[no] dscp {<0..63> | any | class {af11 |
af12 | af13 | af21 | af22 | af23 | af31 |
af32 | af33 | af41 | af42 | af43 | cs0 |
cs1 | cs2 | cs3 | cs4 | cs5 | cs6 | cs7 |
default | wmm_be0 | wmm_be24 | wmm_bk16 |
wmm_bk8 | wmm_vi32 | wmm_vi40 | wmm_vo48 |
wmm_vo56}}
Specifies a DSCP code point value or sets an AF class or QoS
access class of incoming or outgoing packets to which this
policy applies.
any means all DSCP value or no DSCP marker.
The no command resets the DSCP code to the default (any).
To Next Page
Loading...
