Chapter 43 Content Filtering
ZyWALL Series CLI Reference Guide
377
43.4.3 Web Content Filtering Statistics
The following table describes the commands for collecting and displaying web content filtering
statistics. You must use the
configure terminal command to enter the configuration mode before
you can use these commands.
43.4.4 Web Content Filtering Statistics Example
This example shows how to collect and display Web Content Filter statistics.
43.5 DNS Content Filter
The following section describes the commands for the DNS content filter.
43.5.1 DNS Content Filter Commands
The following table lists the commands that you can use for general DNS content filter configuration, Use
the configure terminal command to enter the configuration mode to be able to use these
Table 208 Commands for Content Filtering Statistics
COMMAND DESCRIPTION
[no] content-filter statistics
collect
Turn the collection of Web Content Filter statistics on or off.
content-filter statistics flush
Clears the collected Web Content Filter statistics.
show content-filter statistics
summary
Displays the collected Web Content Filter statistics.
show content-filter statistics
collect
Displays whether the collection of Web Content Filter
statistics is turned on or off.
show content-filter statistics
summary
Displays the current Web Content Filter statistics.
Router(config)# content-filter statistics collect
Router(config)# show content-filter statistics summary
total web pages inspected : 0
web pages warned by category service : 0
web pages blocked by category service: 0
web pages blocked by custom service : 0
restricted web features : 0
forbidden web sites : 0
url keywords : 0
web pages passed : 0
unsafe web pages : 0
other web pages : 0
To Next Page
Loading...
