ZyXEL Communications ZyWALL 310 - 18.2 Policy Route Commands

Chapter 18 Route
ZyWALL Series CLI Reference Guide
170
18.2 Policy Route Commands
The following table identifies the values required for many of these commands. Other input values are
discussed with the corresponding commands.
Table 81 Input Values for General Policy Route Commands
LABEL DESCRIPTION
address_object
The name of the IP address (group) object. You may use 1-31 alphanumeric characters,
underscores(
_), or dashes (-), but the first character cannot be a number. This value is
case-sensitive.
address6_object
The name of the IPv6 address (group) object. You may use 1-31 alphanumeric
characters, underscores(
_), or dashes (-), but the first character cannot be a number.
This value is case-sensitive.
interface_name
The name of the interface.
Ethernet interface: Some Zyxel Device models use gex, x = 1 - N, where N equals the
highest numbered Ethernet interface for your Zyxel Device model.
Other Zyxel Device models use a name such as wan1, wan2, opt, lan1, ext-wlan, or
dmz.
virtual interface on top of Ethernet interface: add a colon (:) and the number of the
virtual interface. For example: gex:y, x = 1 - N, y = 1 - 4
VLAN interface: vlanx, x = 0 - 4094
virtual interface on top of VLAN interface: vlanx:y, x = 0 - 4094, y = 1 - 12
bridge interface: brx, x = 0 - N, where N depends on the number of bridge interfaces your
Zyxel Device model supports.
virtual interface on top of bridge interface: brx:y, x = the number of the bridge interface,
y = 1 - 4
PPPoE/PPTP interface: pppx, x = 0 - N, where N depends on the number of PPPoE/PPTP
interfaces your Zyxel Device model supports.
policy_number
The number of a policy route. 1 - X where X is the highest number of policy routes the
Zyxel Device model supports. See the Zyxel Device’s User’s Guide for details.
schedule_object
The name of the schedule. You may use 1-31 alphanumeric characters, underscores(_),
or dashes (-), but the first character cannot be a number. This value is case-sensitive.
service_name
The name of the service (group). You may use 1-31 alphanumeric characters,
underscores(
_), or dashes (-), but the first character cannot be a number. This value is
case-sensitive.
user_name
The name of a user (group). You may use 1-31 alphanumeric characters, underscores(_),
or dashes (-), but the first character cannot be a number. This value is case-sensitive.
destv6
The IPv6 route prefix (subnet address) for the destination.
prefix
The IPv6 prefix length, 0 - 128.
gatewayv6
The IPv6 address of the specified gateway.
ipv6_addr
An IPv6 address.
ipv6_global_addre
ss
An IPv6 address excluding the link-local address (fe80::).
ipv6_link_local
An fe80:: IPv6 address.