Chapter 42 IDP Commands
ZyWALL Series CLI Reference Guide
361
42.5.1 Update Signature Examples
These examples show how to enable/disable automatic IDP downloading, schedule updates, display
the schedule, display the update status, show the (new) updated signature version number, show the
total number of signatures and show the date/time the signatures were created.
42.6 IDP Statistics
The following table describes the commands for collecting and displaying IDP statistics. You must use
the
configure terminal command to enter the configuration mode before you can use these
commands.
show idp signatures date
Displays the date and time the signature set was
released.
show idp signatures number
Displays the number of signatures in this set.
show idp signatures version
Displays the signature set version number currently
used by the Zyxel Device. This number gets larger
as new signatures are added.
Table 200 Update Signatures
COMMAND DESCRIPTION
Router# configure terminal
Router(config)# idp signature update signatures
IDP signature update in progress.
Please check system log for future information.
Router(config)# idp signature update auto
Router(config)# no idp signature update auto
Router(config)# idp signature update hourly
Router(config)# idp signature update daily 10
Router(config)# idp signature update weekly fri 13
Router(config)# show idp signature update
auto: yes
schedule: weekly at Friday 13 o'clock
Router(config)# show idp signature update status
current status: IDP signature download failed, do 1 retry at Sat Jan 4
22:47:47 2003
last update time: 2003-01-01 01:34:39
Router(config)# show idp signature signatures version
version: 1.2000
Router(config)# show idp signature signatures number
signatures: 2000
Router(config)# show idp signature signatures date
date: 2005/11/13 13:56:03
Table 201 Commands for IDP Statistics
COMMAND DESCRIPTION
[no] idp statistics
collect
Turn the collection of IDP statistics on or off.
idp statistics flush
Clears the collected statistics.
To Next Page
Loading...
