ZyXEL Communications ZyWALL 310 - 32.3.1 Billing Profile Sub-commands; 32.3.2 Billing Command Example

Chapter 32 Hotspot
ZyWALL Series CLI Reference Guide
263
32.3.1 Billing Profile Sub-commands
The following table describes the sub-commands for the billing profile command.
32.3.2 Billing Command Example
This example sets the accounting method to time-to-finish and configures the idle timeout that
elapses before the Zyxel Device disconnects a user.
Table 135 billing profile Sub-commands
COMMAND DESCRIPTION
[no] activate
Enables the billing profile.
The no command disables the profile.
bandwidth {upload | download}
<0..1048576> priority <1..7>
Specifies the maximum bandwidth allowed for the user account in kilobits per
second and types a number between 1 and 7 to set the priority for the user’s
traffic. The smaller the number, the higher the priority.
upload refers to the traffic the Zyxel Device sends out from a user.
download refers to the traffic the Zyxel Device sends to a user.
[no] bandwidth activate
Turns on bandwidth management for the user account.
The no command disables bandwidth management for the user account.
price price
Defines each profile’s price, up to 999999.99, per time unit.
quota {total | upload |
download} megabytes <0..1023>
Sets how much downstream and/or upstream data in Megabytes can be
transmitted through the external interface before the account expires. 0
means there is no data limit for the user account.
quota {total | upload |
download} gigabytes <0..100>
Sets how much downstream and/or upstream data in Gigabytes can be
transmitted through the external interface before the account expires. 0
means there is no data limit for the user account.
quota type {total | upload-
download}
Sets a limit for the user account. This only applies to user’s traffic that is received
or transmitted through the external interface.
Note: When the limit is exceeded, the user is not allowed to access
the Internet through the Zyxel Device.
total: set a limit on the total traffic in both directions.
upload-download: set a limit on the upstream traffic and downstream traffic
respectively.
time-period {day <1..365> |
hour <1..24> | minute
<30..60>}
Sets the duration of the billing period. When this period expires, the user’s
access will be stopped.
Router# configure terminal
Router(config)# billing accounting-method time-to-finish
Router(config)# billing accumulation idle-detection timeout 30
Router(config)#