ZyXEL Communications ZyWALL 310 - 32.5.1 Printer-manager Printer Sub-commands; 32.5.2 Printer-manager Command Example

Chapter 32 Hotspot
ZyWALL Series CLI Reference Guide
269
32.5.1 Printer-manager Printer Sub-commands
The following table describes the sub-commands for the printer-manager printer command.
32.5.2 Printer-manager Command Example
This example adds a printer to the managed printer list and displays the printer settings.
printer-manager printout-type
{customized | default}
Sets to use the default account printout format built into the Zyxel Device or
use a custom account printout format.
show printer-manager button
Displays the name of billing profile that is applied to each button.
show printer-manager discover-
printer-status
Displays information of the printer that is connected to and detected by the
Zyxel Device.
show printer-manager printer
[<1..10>]
Displays settings of all or the specified printer that can be managed by the
Zyxel Device.
show printer-manager printer-
status
Displays information about the printers that are connected and can be
managed by the Zyxel Device.
show printer-manager printerfw
version
Displays the version of the printer firmware currently uploaded to the Zyxel
Device. The Zyxel Device automatically installs it in the connected printers to
make sure the printers are upgraded to the same version.
show printer-manager printout-type
Displays the current account printout format.
show printer-manager settings
Displays the printer management settings.
show printer-manager workableIP
Displays the number and IP address(s) of printer(s) that can synchronize with
the Zyxel Device successfully.
Table 138 printer-manager Commands (continued)
COMMAND DESCRIPTION
Table 139 printer-manager printer Sub-commands
COMMAND DESCRIPTION
activate
Enables the entry.
deactivate
Disables the entry.
description description
Sets a descriptive name for the printer.
printer-ip ipv4_address
Sets the IP address of the printer.
Router# configure terminal
Router(config)# printer-manager printer 1
Router(printer-manager)# activate
Router(printer-manager)# description cafe
Router(printer-manager)# printer-ip 172.16.0.123
Router(printer-manager)# exit
Router(config)# show printer-manager printer
printer: 1
activate: yes
IPv4 address: 172.16.0.123
description: cafe
Router(config)#