ZyXEL Communications ZyWALL 310 - 19.2.5 Learned Routing Information Commands; 19.2.6 Show IP Route Command Example; 19.3 BGP (Border Gateway Protocol)

Chapter 19 Routing Protocol
ZyWALL Series CLI Reference Guide
182
19.2.5 Learned Routing Information Commands
This table lists the commands to look at learned routing information.
19.2.6 Show IP Route Command Example
The following example shows learned routing information on the Zyxel Device.
19.3 BGP (Border Gateway Protocol)
The Zyxel Device supports eBGP (exterior Border Gate Protocol) to route IPv4 traffic between routers in
different Autonomous Systems (AS). An AS number is a number from 1 to 4294967295), that identifies an
autonomous system. 4200000000 – 4294967294 are private AS numbers.
area IP virtual-link IP message-digest-
key <1..255> md5 authkey
Sets the MD5 ID and password for MD5 authentication in the
specified virtual link.
area IP virtual-link IP message-digest-
key <1..255> encrypted-authentication-
key
Sets the MD5 ID in the specified virtual link
no area IP virtual-link IP message-
digest-key <1..255>
Clears the MD5 ID in the specified virtual link.
Table 90 router Commands: Virtual Links in OSPF Areas (continued)
COMMAND DESCRIPTION
Table 91 ip route Commands: Learned Routing Information
COMMAND DESCRIPTION
show ip route [kernel | connected | static | ospf
| rip | bgp]
Displays learned routing and other routing information.
Router> show ip route
Flags: A - Activated route, S - Static route, C - directly Connected
O - OSPF derived, R - RIP derived, G - selected Gateway
! - reject, B - Black hole, L - Loop
IP Address/Netmask Gateway IFace Metric Flags
Persist
===========================================================================
0.0.0.0/0 172.16.1.254 wan1 0 ASG -
10.59.0.0/24 0.0.0.0 ext-wlan 0 ACG -
127.0.0.0/8 0.0.0.0 lo 0 ACG -
172.16.1.0/24 0.0.0.0 wan1 0 ACG -
192.168.1.0/24 0.0.0.0 lan1 0 ACG -
192.168.2.0/24 0.0.0.0 lan2 0 ACG -
192.168.3.0/24 0.0.0.0 dmz 0 ACG -